AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Dell docking station d6000 macbook pro11/24/2023 Multi display works fine on my MacBook Pro 13 M1, but a (very) jarring issue is that the D6000 is unable to recognize any peripherals through all 4 USB-A ports and even USB-C. If only one monitor is shown and the other monitor is not.Made a recent purchase to try out the multi display feature with D6000.Ensure to select the correct video source on your monitor (refer to your monitors documentation for more information about changing the video source) Make sure the video cable (HDMI or DisplayPort) is connected properly to the monitor and the dock.Refer to the Display Resolution Table in the User Guide of your dock for more information on maximum resolution capacity Your monitor may support higher resolutions than what the dock is able to support. Check the resolution settings on your computer.You can enable the video output under Control Panel\Display\Change Display Setting If your monitor is connected to the dock, the video output on your computer may be disabled.No video on the monitors attached to High Definition Multimedia Interface (HDMI), or DisplayPort (DP) port on the dock Check with your notebook manufacturer to confirm power charging compatibility with the dock.Make sure the notebook’s USB-C port accept power charging.Disconnect and re-connect the dock cable to your computer Make sure the LED of your dock is ON (White LED).Make sure the dock is connected properly to its own power adapter.Laptop fail to power charge when the dock is connected to your computer Check the settings under BIOS Items to make sure laptop supports wake-up-from-Ethernet port function.Laptop failed to wake up from Ethernet port Download and install the latest graphics drivers for your primary graphics card.Windows 7 onwards is not designed to operate without WDDM drivers. This message will appear if the primary graphics card drivers installed are not WDDM compatible. The situation may also be improved by rebooting the PC The PC does not have enough memory to start an extend display This can occur when entering extend mode with low system resources. Insufficient system resources exist to complete the requested service Download the driver from an Internet connected computer and copy the driver over USB flash drive, and run the setup.Some unqualified boot devices may cause a lockup during bootįirst time Internet access causing error message
0 Comments
Read More
Leave a Reply. |